How a pipe speaks

Wind goes in at the foot and something has to cut it

There are two ways to do that, and only two. A flue pipe cuts the wind at a mouth. A reed pipe sets a brass tongue beating against a shallot. We make the first kind. This page is the difference, drawn properly.

Flue pipe

Prestant, fluit, gedekt. Everything we make.

  • Upper lipThe edge the wind strikes. Its height above the mouth is the cut-up, and it decides how brightly the pipe speaks.
  • MouthA rectangle cut through the wall where foot meets body. No mouth, no flue pipe.
  • LanguidA flat plate inside, just under the mouth. It leaves a windway a few tenths of a millimetre wide.
  • BodyThe sounding tube. Open at the top on a Prestant, closed by a stopper on a Gedekt.
  • FootThe cone that sits in the rack board. The hole in its tip meters the wind.

Reed pipe

Trompet, schalmei. Voiced in Dongen, not here.

  • ResonatorThe cone on top. It does not make the sound, it selects which part of the sound you hear.
  • BootThe closed cup under the resonator. All the wind arrives here first and there is no mouth anywhere on the pipe.
  • ShallotA small brass tube with one face filed flat and open. The tone of the whole stop lives in that face.
  • TongueA brass strip laid over the open face. Wind drives it shut, it springs back, and that beating is the sound.
  • Tuning wireA hook that shortens the free length of the tongue. Push it down and the pitch rises.
The useful trick

Stop the top of a pipe and it drops an octave

Close the far end of a flue pipe with a stopper and the air column folds back on itself. The pipe then needs only half the length for the same note. A stopped wooden Gedekt whose body measures 1.22 m speaks at eight foot pitch, the same note as an open Prestant standing 2.44 m beside it.

That is how a small chamber organ keeps a bass. It also changes the tone: a stopped pipe drops its even harmonics and comes out hollow and flutey, which is exactly why a Gedekt sounds nothing like a Prestant on the same note.

Timber for stopped bodies
Open, 2.44 mEight foot pitch
Stopped, 1.22 mEight foot pitch
What we use, and sell

Three tools do most of the voicing

Nothing exotic. A scraper to adjust a languid, a cone to open or close a top, dividers to step a mouth width round the circumference. All three come off our own bench.

A pair of brass dividers standing point down on a pale surface.

Bench tools

Brass dividers

€74

Solid brass, 200 mm · for stepping out a mouth width

Two hands filing a small metal part held in the jaws of a bench vice.

Tell us your wind pressure and we will voice to it

A pipe voiced at 72 mm will not behave at 95 mm. Send the figure with your order, or send the chest if you would rather we checked it ourselves. Mariëlle writes the pressure inside every foot before the crate is closed, so whoever opens that pipe in fifty years knows what it was built for.

Send your pressure