Lead, tin and timber

The alloy is the instrument, long before anybody plays it

Three alloys get poured on a sand bed in the back room. Timber we buy whole and stack for years. Below is what each does, and what each costs, with no figure rounded our way.

A hand steadying a workpiece at a lathe while shavings fly off the cutter.
More tin, brighter, dearer

Three pours, and the work each one suits

Tin is roughly nine times the price of lead by weight, and it carries the brightness. Lead is soft, cheap and warm. Everything between the two is a choice about tone and about money, in that order if we can help it.

  • 50per cent tin
    Spotted metalBright and firm, with the mottled skin it is named for. Holds a tall body straight. Our dearest sheet at €188 the half square metre.
  • 30per cent tin
    Common metalWarmer, rounder, and a third cheaper at €126. The right choice for flutes and for anything that must not shout in a small room.
  • 15per cent tin
    Lead richSoft, dark and slow to speak. We roll it only for short basses that sit on a rack board, because a tall body in this metal will lean within ten years.
A ribbed metal panel lit so the ridges throw straight shadows.

Cast on sand, never rolled thin from a billet

The pour runs down a long sand bed behind a moving box. The sheet that comes off has a crystalline skin on one face and takes a plane beautifully. We cast thick at the bass end and thin at the treble in a single run, so a tall pipe carries weight where it needs it and nowhere else.

Rolled sheet is cheaper and more even, and it is why so much twentieth century pipework sags. It has never come through this door and it never will.

The timber side

Oak for stopped bodies, pine for open ones

Wooden pipes move with the weather, so the board matters more than the joinery. We buy quartered, which means cut through the heart, because those boards cup far less when a church dries out in February. Then we stack them in the yard for six to eight years before anything is cut.

Oak is dense and keeps a stopper tight, which is why it gets the Gedekt work. Pine is lighter and speaks more freely, which suits an open body. Pear goes into the stoppers and caps, where we want something that machines cleanly and stays put.

See the timber we stock
A grey metal plate marked with scratches and small bright flecks.

Pipe metal

Thirty tin sheet

€126

Cast on sand and planed · 1000 × 500 mm · 1.6 mm

We will quote on your alloy, not ours

If a restoration needs an exact match we will have a sample analysed and pour to it, including the odd historic mixes with a little antimony in them. Allow three weeks for the analysis and tell us how much sheet you need, because a single pour is cheaper than three small ones.